Z-Wave Everspring SP103

Description

The Motion Detector is a Z-Wave enabled device and is fully compatible with any Z-Wave enabled network.


Include

  • In the rear casing, there is a tamper switch which is used to carry out inclusion, exclusion or association. Put a Z-WaveTM Wireless Controller into inclusion/exclusion mode, press the tamper switch on the detector to complete the inclusion/exclusion process. The Motion Detector will stay “awake” for ten minutes when changing the status of tamper switch from being pressed to be released or from being released to be pressed to allow time for configuration.


Exclude

  • Not Possible … Run include again?


Tips & Tricks


Related Resources


    Updated by: Alexie, Updated almost 5 years ago
    Access count: 67380

    Attached Files

    Everspring-SP103_in_en.pdf (1.23 MB) Alexie, 11/13/2013 07:36 PM

    everspring-sp103.jpg (6.09 KB) Alexie, 11/13/2013 07:36 PM

    Also available in: PDF HTML TXT