Z-Wave Fibaro FGBS001

Description

The Universal Binary Sensor is a wireless module that makes it possible to improve the functionality of any sensor with a binary output by allowing it to communicate with the wireless network Z-Wave. Moreover, the module allows for wireless communication between the system and the DS18B20 temperature sensors. The device can service up to two binary sensors and up to four DS18B20 temperature sensors.


Include

  • The Fibaro Sensor is added to the network by quickly pressing the B button three times (the button is located in the center of the device)


Exclude

  • Resetting by cutting off the power supply and re-connecting the power supply while holding down the B button – after 10 seconds, after another cut-off and re-connection of power supply the settings of the device will be reset


Tips & Tricks

Adding DS1820 Sensor(s)

Every time when any changes are made to the configuration of TP and TD lines (1-wire), e.g. when DS18B20 sensor(s) is (are) included/excluded, it is necessary to execute the procedure of exclusion and repeated inclusion of the sensor module with the Z-Wave controller. This will also change Z-Wave device number, please also update your device information in DomotiGa.

Related Resources


    Updated by: danfos, Updated over 3 years ago
    Access count: 66172

    Attached Files

    fibaro-fgbs001.jpg (19.8 KB) Alexie, 11/13/2013 07:13 PM

    Fibaro-Universal_Sensor_FGBS321_v12_ENG.pdf (1.17 MB) Alexie, 11/13/2013 07:27 PM

    Also available in: PDF HTML TXT