Z-Wave Fibaro FGWPF/E 101


The Fibaro Wall Plug with power metering feature is an intelligent, ultimate plug & play, extremely compact, most sophisticated, remotely controlled outlet adapter. The Plug features power
consumption measuring and uses a crystal LED ring to visualize the current load by colour changing illumination.

The plug comes in at least 2 variations:
  • FGWPF - To be used in the Netherlands
  • FGWPE - To be used in Belgium/France


This Z-Wave device will go into an auto-inclusion mode if it isn't included into a network yet:

  • Auto-inclusion will be activated, i.e. Plug automatically start looking for Z-Wave network controller. Auto-inclusion activation is signaled by a single, red, LED ring blink.
  • Set the Z-Wave network main controller into learning mode (see Z-Wave network controller operating manual)

Manual option:

  • Triple click the B button, located on the Plug's casing


  • Insert the Plug into a socket
  • Set the Z-Wave network controller into the learn-mode or exclude-mode (see Z-Wave controller operating manual)
  • Triple click the B button, located on the Plug's casing


  • Insert the Plug into a socket
  • Press and hold the B button for 15 - 20 seconds until LED ring glows yellow
  • Release the B button
  • Press the B button, briefly
  • Once the reset procedure is completed, LED ring will glow red and turn off. Plug's relay will turn off as well

Value Mapping

The Z-Wave information, device values are mapped to internal DomotiGa values. The following mapping is applied for this device:

Value Type Units Example
value1 Switch On/Off
value2 Current Energy Usage W 0
value3 Power Usage kWh 0
value4 Current Power Usage W 0

Tips & Tricks

Related Resources

    Updated by: Alexie, Updated about 4 years ago
    Access count: 67861

    Attached Files

    Also available in: PDF HTML TXT